Gift Certificates
The perfect gift for RVers!
Newsletter Signup

Newsletter Signup

Enter email address

SlimLine Dish Folding LNB Arm Kit - No. 2

SKU: HG-309
Price:
$24.95

Options:
Qty: - +
   - OR -   

This kit replaces all the adjustment hex nuts on your DirecTV Slimline satellite dish with wing nuts, eliminating the need for a wrench to loosen the hex nuts when making adjustments to the dish settings. It also adds hardware to allow the LNBF arm to be raised to a compact storage position without allowing the LNBF heads to contact the face of the dish, preventing damage to the heads.

Conversion requires drilling 6 holes with a 1/4" drill bit to replace the existing LNB bracket with the replacement bracket from the kit. Download the instructions below for further installation details.

IMPORTANT - PLEASE READ - This kit will ONLY work on one model of the Slimline dish. The Slimline dish is made in at least four different model. Your LNB arm MUST LOOK EXACTLY like the one pictured in Fig. 1 below. If it does not, this kit will not fit your dish.

NEW!

knob.jpg (36761 bytes)

We now offer this kit in a DELUXE MODEL that replaces the standard wing nuts with T Knobs for an easier grip.  Select the DELUXE MODEL from the pull-down options menu above.

Complete detailed instructions included.

PLEASE VISIT OUR FOLDING LNB KIT SELECTION PAGE TO ENSURE YOU SELECT THE CORRECT KIT FOR YOUR DISH

FIG. 1

LNBF bracket from kit installed on existing LNB arm.

The Slimline dish is made in several model variations. The difference is in the manner the LNB arm connects to the frame. For this kit to work on your dish it must look EXACTLY like the arm in Fig. 1 above. If your dish is different please view our Folding LNB Arm Selection Chart for an alternative kit

The Slimline dish is quite large and bulky with the LNB arm extended as above

 

With the Slimline Folding LNB Arm Kit installed the dish takes up over 50% less room when folded.

DOWNLOAD SLIMLINE DISH FOLDING LNB ARM KIT - No.2 INSTRUCTIONS PDF FILE 1.33MB

Gary Hutchcraft on 06/14/2014 07:16am
This kit is so nice! The instructions were spot on and the conversion was easy. The arm is sturdy and it works just like the non-folding arm. Finally I have only a 2 part dish that stores in my compartment without disassembly, except to remove the tripod. I have cut my setup time to 15 minutes. Great job George!
Gordon Sims on 04/01/2013 01:36pm
I don't actually have this kitĚ as I have a Dish 1000 with Dish Network. However after reading how it folds and pondering how to fit the huge 1000 into my storage bays, I modified my Dish 1000 to work the same way. I made the arm fold up and added wing nuts and a fine tune arm to the Dish Network dish. It makes a huge difference in storing and adjusting. On the Dish 1000 it's a bit of surgery and it helps if you own a mig welder. Would recommend this kit to anyone who has the dish assembly it fits.

Add Your Review


Your Name:
Email Address:
Review:
Note: HTML is not translated! Your email address will not be shared with anyone.
Your Rating: 5
Verification: The Captcha image
Reload Image  |  Phonetic Spelling

Your Name:
Your Email:
Friends Name:
Friends Email:
Subject:
Message:
Verification: The Captcha image
Reload Image  |  Phonetic Spelling

Shop with Confidence